Energy storage system installation costs

Which energy storage technologies are included in the 2020 cost and performance assessment?

The 2020 Cost and Performance Assessment provided installed costs for six energy storage technologies: lithium-ion (Li-ion) batteries, lead-acid batteries, vanadium redox flow batteries, pumped storage hydro, compressed-air energy storage, and hydrogen energy storage.

Are energy storage systems cost estimates accurate?

The cost estimates provided in the report are not intended to be exact numbers but reflect a representative cost based on ranges provided by various sources for the examined technologies. The analysis was done for energy storage systems (ESSs) across various power levels and energy-to-power ratios.

How much does gravity based energy storage cost?

Looking at 100 MW systems, at a 2-hour duration, gravity-based energy storage is estimated to be over $1,100/kWh but drops to approximately $200/kWh at 100 hours. Li-ion LFP offers the lowest installed cost ($/kWh) for battery systems across many of the power capacity and energy duration combinations.

How much does a non-battery energy storage system cost?

Non-battery systems, on the other hand, range considerably more depending on duration. Looking at 100 MW systems, at a 2-hour duration, gravity-based energy storage is estimated to be over $1,100/kWh but drops to approximately $200/kWh at 100 hours.

What are the benchmarks for PV and energy storage systems?

The benchmarks in this report are bottom-up cost estimates of all major inputs to PV and energy storage system (ESS) installations. Bottom-up costs are based on national averages and do not necessarily represent typical costs in all local markets.

What are the different types of energy storage costs?

The cost categories used in the report extend across all energy storage technologies to allow ease of data comparison. Direct costs correspond to equipment capital and installation, while indirect costs include EPC fee and project development, which include permitting, preliminary engineering design, and the owner’s engineer and financing costs.